- Caddx Nx 8 Programming Manual 2017; Caddx Nx 8 Programming Manual Download; GE Caddx Alarm Systems. The GE Caddx Networx line of security systems offer many of the features of more complicated alarms, but at very reasonable prices. The 3 main panels are the GE NX-4, NX-6, and the NX-8. The smallest is the NX-4, with 8 on-board zones.
- NX-8/NX-8E claim blocks of 8 so if a sensor is learned into zone 9 then zones 10 to 16 must also be wireless. Addressing Keypad must be addressed to in order to enter wireless programming, NX panels can have multiple receivers. NX-8E = 8 receivers maximum. NX-8 = 4 receivers maximum. NX-6 = 3 receivers maximum. NX-4 = 4 receivers maximum.
ARMING IN “EXIT” MODE EXIT is used when the user is away from the premises
Select the module to program Since all modules connected to the NX-8V2 are programmed through the keypad, the module you are programming should be the first entry. To select the module to program, enter 0, #. The 0 is the module number of the control, and # is the entry key. Jason of Alarm System Store takes you through a tutorial on programming the Interlogix NetworX NX4, NX6, or NX8 alarm panels. He steps you into programming b. Page 8 NX-4 Control Local Programming Lockout This feature will disable programming of all locations or specified locations from the keypad. 21, page 16) Log Full Report A report can be sent to the central station when the event log is full.
and wants the interior protected (the motion detectors ON).
ARMING IN “STAY” MODE STAY is used when the user is inside the premises and
wants protection around the perimeter (the motion
DISARMING SYSTEM Enter code.
user code, enter * * * * for a 4-digit code.
7. Press the “#” key while the ready light is flashing to
BYPASSING ZONES System must be in disarmed state.
2. Enter 1 or 2 digits indicating the zone you wish to
bypass. (Example: Press the “1” key for zone 1,
4. The corresponding zone light will illuminate indicating
the zone has been bypassed. Repeat steps #2 and #3 for
any other zone(s) that need to be bypassed.
5. Press the “#” key to exit the Bypass Mode. The bypass
light will stop flashing upon exiting the Bypass Mode.
All zones will automatically be unbypassed each time the
system is disarmed.
2. The ALARM MEMORY feature will flash those zones
that created alarms and will light steady those zones that
IDENTIFYING TROUBLES
FLASHING ARMED LIGHT The armed light will flash when there has been
an alarm during the previous arm cycle.
POWER LIGHT OFF No AC power.
POWER LIGHT FLASHING Low system battery.
FIRE LIGHT FLASHING Trouble with fire device or wiring.
How To Program Caddx Nx 8 Wiring Kit
ZONE LIGHT FLASHING RAPIDLY A zone is in a trouble condition.
Ge Caddx Nx 8 Manual
SERVICE LIGHT IS ON Press “*2” for further information (indicated by
zone lights).
How To Program Caddx Nx 8 Wiring Diagram
Zone 1 – System fault.
Zone 2 – Zone tamper.
Zone 5 – Zone trouble.
Zone 6 – Telephone trouble.
Zone 7 – Dialer failure.
Zone 8 – System lost time.
Enter “#” to exit mode.
ENTER CODE TO SILENCE TROUBLE BEEPS.
ENTER “*7” TO ATTEMPT TO RESET TROUBLES.
ENTER CODE TO CLEAR SERVICE LIGHT AFTER A PHONE TROUBLE HAS BEEN CLEARED.
SET CLOCK 1. Press “*97.”